Приглашаем посетить
Мода (modnaya.ru)

Recipe 16.3. Replacing the Current Program with a Different One

PreviousChapter 16
Process Management and Communication
Next
 

16.3. Replacing the Current Program with a Different One

Problem

You want to replace the running program with another, as when checking parameters and setting up the initial environment before running another program.

Solution

Use the built-in exec function. If exec is called with a single argument containing metacharacters, the shell will be used to run the program:

exec("archive *.data")
    or die "Couldn't replace myself with archive: $!\n";

If you pass exec more than one argument, the shell will not be used:

exec("archive", "accounting.data")
    or die "Couldn't replace myself with archive: $!\n";

If called with a single argument containing no shell metacharacters, the argument will be split on whitespace and then interpreted as though the resulting list had been passed to exec:

exec("archive accounting.data")
    or die "Couldn't replace myself with archive: $!\n";

Discussion

The exec function in Perl is a direct interface to the execlp (2) system call, which replaces the current program with another, leaving the process intact. The program that calls exec gets wiped clean, and its place in the operating system's process table is taken by the program specified in the arguments to exec. As a result, the new program has the same process ID ($$) as the original program. If the specified program couldn't be run, exec returns a false value and the original program continues. Be sure to check for this.

If you exec yourself into a different program, neither your END blocks nor any object destructors will be automatically run as they would if your process actually exited.

See Also

The exec in Chapter 3 of Programming Perl and in perlfunc (1); your system's execlp (2) manpage (if you have it); Recipe 16.2


PreviousHomeNext
16.2. Running Another ProgramBook Index16.4. Reading or Writing to Another Program